Assembly - Char-Broil The Big Easy 10101550 Product Manual

ASSEMBLY

Tools required for assembly:
Phillips Screwdriver (Not Supplied); Small Adjustable Wrench (Not Supplied)
1 • Carefully turn the unit upside down.
Slide Heatshield into place over the exposed burner tube.
•
• While holding the Heat Shield in place, slide the Control Panel Assembly into place, taking care to ensure that
2
the valve engages the burner tube. shown Figure A
• Install two #10x3/8" self-tap screws through the right side of the control panel. Leave screws loose.
•
Make sure valve is inside burner tube. Align the heat shield as shown Figure B.
Secure control panel using the two remaining #10x3/8" self-tap screws. Tighten all four screws.
Fig. A
Burner
Tube
Proper Valve to Burner Tube installation
(veiw from underneath control panel)
Screw hole
for leg - used
later.
Heat shield
Carefully insert valve end into burner tube making sure valve is centered with burner tube,
after aligned correctly, loosely secure with two self-tap screws on RH side of control panel.
Valve
End
Screw hole
for leg - used
later.
Fig. B
Control
Panel
Align hole in
Heat Shield
with end of
Burner Tube
Hold Heat Shield in place while attaching Control Panel
Ignitor Wire Ignitor Wire
NOTE:
Ensure that the valve engages the burner tube
Heat Shield in Position
Qty: 4
#10x3/8"
Self-Tap Screw
NOTE:
Install these
screws first!
Page 13