Table of Contents
Advertisement
To obtain a more detailed electronic copy of this User Manual or to access live chat support, go to www.philips.com/support
1 Notice
Trademarks are the property of Koninklijke Philips N.V. or
their respective owners.
P&F USA reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
The material in this manual is believed adequate for the
intended use of the system. If the product or its individual
modules or procedures are used for purposes other than
those specified herein, confirmation of their validity and
suitability must be obtained. P&F USA warrants that the
material itself does not infringe any United States patents. No
further warranty is expressed or implied.
P&F USA cannot be held responsible neither for any errors
in the content of this document nor for any problems as a
result of the content in this document. Errors reported to P&F
USA will be adapted and published on the P&F USA support
website as soon as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although
it has effective pixels of 99.999% or more, black dots or bright
points of light (red, green or blue) may appear constantly on
the screen. This is a structural property of the display (within
common industry standards) and is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove
covers to the inside of the product. Repairs may only be done
by Service Centers and official repair shops. Failure to do so
shall void any warranty, stated or implied.
Any operation expressly prohibited in this manual, any
adjustments or assembly procedures not recommended or
authorized in this manual shall void the warranty.
Federal Communications Commission Notice
This equipment has been tested and found to comply with
the limits for a Class B Digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that
•
to which the receiver is connected.
•
Consult the dealer or an experienced radio or television technician
for help.
Declaration of Conformity
: PHILIPS
Trade Name
: P&F USA, Inc.
Responsible Party
: 32PFL4902
Model
: PO Box 2248, Alpharetta, GA
Address
30023-2248 U.S.A.
Telephone Number : 1 866 813 3283
Modifications
This apparatus may generate or use radio frequency energy.
Changes or Modifications to this apparatus may cause
harmful interference.
Any Modifications to the apparatus must be Approved by
P&F USA.
The user could lose the authority to operate this apparatus
if an unauthorized Change or Modification is made.
Cables
Connections to this device must be made with shielded
cables with metallic RFI / EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B)
Analog and Digital Television Receiving Apparatus,
Canada BETS-7 / NTMR-7.
The following FCC/IC RSS applies to the
Wireless LAN adapter included in this product.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Country Code Statement
For product available in the USA market, only channel 1 1 1
can be operated. Selection of other channels is not possible.
To maintain compliance with FCC RF exposure requirements,
use only belt-clips, holsters or similar accessories that do not
contain metallic components in its assembly. The use of
accessories that do not satisfy these requirements may not
comply with FCC RF exposure requirements and should be
avoided.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference and (2)
this device must accept any interference, including interference
that may cause undesired operation of the device.
4
Advertisement
Table of Contents
