Char-Broil Commercial 463257010 Product Manual page 23

13
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of
door, and release hinge pin into door.
14
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart right
side panel with the nut and cap, shown A.
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. otal (5) connections.
T
Connect the two wires(A and B) from the switch wiring harness into the back of the Electronic Ignition Module.
Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown
as A, B. Do not untie the wires while attaching.
Electronic
ignition module
Left door
Right side panel
Heat shield
Nut
Right door
A
Cap
PRESS
3
A
4
1
5
2
B
Wire
Top of
door
Hinge pin
on bottom
of door
23