Checking The Heat Exchanger Unit; Inserting The Plinth Filter - Miele TWB 120 WP Operating Instructions Manual

Cleaning and care

Checking the heat exchanger unit


Risk of injury from sharp cooling
fins.
You could cut yourself.
Do not touch the cooling fins with
your hands.
 Look to see if lint has accumulated.
If there is visible soiling:

Damage due to incorrect
cleaning of the heat exchanger.
The dryer will not dry if the cooling
fins are damaged or bent.
Use a vacuum cleaner with a dusting
brush attached to clean the cooling
fins. Only pass the vacuum cleaner
brush over them lightly, without
applying any pressure.
 Carefully vacuum up any visible lint or
dirt.
44

Inserting the plinth filter

 Fit the filter back on the handle. Make
sure it is the correct way round.
To ensure that the filter is positioned
correctly in front of the heat exchanger
unit:
 First insert the handle with the plinth
filter attached over the two guide
pins:
– The word Miele on the handle must
be the correct way up.
 Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.
 Close the heat exchanger flap.