Table of Contents
Advertisement
Installation
en
Insert the two bolts on the ceiling through the
2.
openings provided in the frame
to allow the bolts to be screwed into the keyhole
openings
.
©
Use two more bolts to screw the frame in place.
3.
Tighten all the bolts fully.
Insert the four cables into the openings provided in
4.
the frame and thread them through the labyrinth.
14
¨
. Move the frame
ª
Establishing a connection to the mains
:
Warning
Risk of electric shock!
It must always be possible to disconnect the appliance
from the power supply. If there is a fixed connection, an
all-pole isolating switch with a contact gap of at least
3 mm must be provided for the wiring. Only an
electrician may install the fixed connection.We
recommend installing a residual-current circuit breaker
(RCCB) in the appliance's power supply circuit.
To find out the correct fuse rating, see the total
Note:
connected load (in watts) on the appliance's rating
plate.
Position the appliance underneath the frame.
1.
Carefully thread the cables and the mains power
2.
cable through the opening in the frame cover. Place
the frame cover down onto the appliance.
Mount the appliance on the wall and level it; see the
3.
section entitled "Wall-mounting the appliance and
levelling it".
Thread the mains power cable through the opening
4.
in the frame and then through the strain relief.
Caution!
Do not position the mains power cable that is inside
the frame underneath the frame.
Connect the appliance to the power supply.
5.
Caution!
Pay attention to the marks on the connection
terminals when connecting the wires (permissible
cross sections of the domestic wiring: 1 mm² -
2.5 mm²) in the mains power cable.
Use an open-ended spanner (WAF 17) to tighten the
6.
strain relief until the mains power cable is held firmly
and cannot move.
Advertisement
Table of Contents
