NEC LS-D2462CL Owner's Manual page 12

Auto Operation
During Auto Operation:
You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.
If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must
be done by manually resetting.
During Auto Operation, pressing the Airflow direction Start/Stop button makes the horizontal louvers
swing up and down automatically. If you want to stop auto-swing, press the Airflow Direction
Start/Stop button again.
Press the Start/Stop button. The unit will respond with a beep.
1
Open the door on the remote control. To select Auto
2
operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is shifted
in the direction of the arrow.
Cooling
The temperature and fan speed are automatically set by the
3
electronic controls based on the actual room temperature. If
you want to change the set temperature, close the door on
the remote control and press the Room Temperature Setting
buttons. The cooler or warmer you feel, the more times (up to
two times) you should press the button. the set temperature
will then be changed automatically.
12
Soft Dry Auto
(Heat pump model only)
To raise the temperature
To lower the temperature
Heating