Table of Contents
Advertisement
Fitting the appliance
Hook the appliance from below into the support frame.
1.
Note: Ensure that the mains cable is not trapped.
Fasten the appliance to the support frame using 2 securing
2.
screws.
Hook in the retaining clip and screw tight.
3.
Connecting the pipes
Note: If using an aluminium pipe, smooth the connection area
beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe connector
and seal.
Exhaust-air pipe Ø 120 mm
Attach the reducing connector directly to the air-pipe
1.
connector.
Attach the exhaust air pipe to the reducing connector.
2.
Seal both joints appropriately.
3.
Attaching the flue duct
:
Risk of injury!
From sharp edges during installation. Always wear protective
gloves while installing the appliance.
Separate the flue ducts.
1.
To do this, remove the adhesive tape.
Remove the protective foil from both sides.
2.
Place both parts of the upper flue on the appliance and push
3.
together.
Note: The slots of the upper flue must point downwards.
Push up the upper flue part and secure with 2 screws.
4.
Insert both lower parts of the flue and push together.
5.
15
Advertisement
Table of Contents
