Table of Contents
Advertisement
7.
Use the four M5 screws removed from the ceiling-mount
bracket during preparation.
8.
Hook the base bracket on the protrusion (A) of the joint
fitting, and secure it temporarily using the four supplied
M5 screws (B).
9.
Mount the terminal clamp on the other end of anti-fall
wire to the joint fitting (C), and secure it at the wire-
attaching position using M4 screw.
■
Pull out the cables.
■
Be sure to secure screws (B) tightly after making
the adjustment discussed in
Angle" on page 91.
10. Pull the cables out of the cable hole in the ceiling.
11. Put the cables inside the pipe.
12. Close the inner cover of the pipe and then close outer
cover of the pipe. Secure to the extension pipe using the
supplied M3 screw.
13. Connect the cables to the projector.
After completion of installation, adjust the projection
angle (page 91).
"Adjust the Projection
90
Direction to the
screen
A
B
B
C
Advertisement
Table of Contents
