Table of Contents
Advertisement
Speech
The audio commentary can also hold subtitles for the
words which are spoken.
To switch on these subtitles (if available) . . .
1 - Press and select Setup and press OK.
2 - Select Satellite settings > Languages > Audio
description > Speech and press OK.
3 - Select Descriptive (audio) or Subtitles and press
OK.
4 - Press , repeatedly if necessary, to close the
menu.
Manual installation
Manual installation is intended for expert users.
You can use Manual installation to quickly add new
channels from a satellite transponder. You need to
know the frequency and polarization of the
transponder. The TV will install all channels of that
transponder. If the transponder was installed before,
all its channels - the former and the new ones - are
moved to the end of the channel list All.
You cannot use Manual installation if you need to
change the number of satellites. If this is needed, you
have to do a complete installation with Install
satellites.
To install a transponder . . .
1 - Press and select Setup and press OK.
2 - Select Satellite settings > Channel installation >
Manual installation and press OK.
3 - If you have more than 1 satellite installed, select
the satellite/LNB for which you want to add channels.
4 - Set the Polarization you need. If you set the
Symbol rate mode to Manual, you can enter the
symbol rate in Symbol rate manually. Enter the
Frequency and start searching for the transponder.
5 - If a transponder is found, select Store and press
OK to store the new transponder on the selected
LNB.
6 - Select Exit to leave the manual installation.
8.6
Problems with satellites
The TV cannot find the satellites I want or the TV
installs the same satellite twice
• Make sure that the correct number of satellites is set
in Settings at the start of the installation. You can set
the TV to search for One, Two or 3/4 satellites.
A dual head LNB cannot find a second satellite
• If the TV finds one satellite but cannot find a second
one, turn the dish a few degrees. Align the dish to get
the strongest signal on the first satellite. Check the
signal strength indicator of the first satellite on screen.
With the first satellite set at the strongest signal, select
Search again to find the second satellite.• Make sure
the settings are set to Two satellites.
Changing the installation settings did not solve my
problem
• All settings, satellites and channels are only stored
at the end of the installation when you finish.
All satellite channels are gone
• If you use a Unicable system, make sure you
assigned a unique user band number to the satellite
receiver in the Unicable settings. It might be that
another satellite receiver is using the same user band
number.
Some satellite channels seem to have disappeared
from the channel list
• If some channels seem to be gone or displaced, the
broadcaster might have changed the transponder
location of these channels. To restore the channel
positions in the channel list, you can try an update of
the channel package.
I cannot remove a satellite
• Subscription packages do not allow removing a
satellite. To remove the satellite, you have to do a
complete installation again and select another
package.
Sometimes the reception is poor
• Check if the satellite dish is solidly mounted. Strong
winds can move the dish.
• Snow and rain can degrade the reception.
40
Advertisement
Table of Contents
