Hitachi E24SB Safety Instructions And Instruction Manual page 13

USING ELECTRIC POWER
1. Turn off the switch(es) of the electrical appliance(s) before connecting to the
generator.
2. Insert the plug(s) of the electrical appliance(s) into the receptacle.
● Use 16 ampere type receptacles.
● Be sure that the total wattage of all appliances does not exceed the rated
output of the generator.
3. Turn on the switch(es) of the electrical appliances.
WARNING: Be sure to ground the generator if the connected electrical
equipment is grounded.
NOTE: When the generator is overloaded, the circuit breaker will
automatically activate to protect the generator and stop its output.
Reduce the load to within the specified limits and reset the circuit
breaker. Following this, restart the generator.
STOPPING THE GENERATOR
1. Turn off the power switch of the electric equipment or unplug the cord from
receptacle of the generator.
2. Allow the engine about 3 minutes to cool down at no-load before stopping.
3. Set the engine switch to "STOP" position.
4. Close (stop) the fuel cock.
Fig. 19
English
Fig. 16
Fig. 17
Fig. 18
CLOSE
Fig. 20
13