Table of Contents
Advertisement
Operating the appliance
en
Control panel model 2
Symbol
Explanation
Fan on/off
#
1-3
Fan settings
Intensive mode 1
C
Intensive mode 2
D
Fan run-on
y
Automatic mode
>
Metal grease filter saturation indicator
E
Activated charcoal filter saturation indicator
F
Light on/off/dimming
B
Setting the fan
Switching on
Touch the
#
symbol.
The fan starts at fan setting 2.
Selecting the fan setting
Touch symbol 1, 2 or 3 to set a different fan setting.
Switching off
Touch the
symbol.
#
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Switching on
Touch the
or
C
After approx. 6 minutes, the extractor hood
Note:
automatically switches back to fan setting 3.
Switching off
If you want to end intensive mode before the preset
time expires, touch the symbol for the required fan
setting.
Intermediate position for the glass front
On some appliances, the glass front can be adjusted to
an intermediate position. The intermediate position can
be used for eliminating particularly strong cooking
smells and large amounts of steam.
Take hold of the glass front in the centre and open it
carefully.
8
symbol.
D
Fan run-on time
Switching on
Touch the
y
symbol.
The fan will run at fan setting 1.
After approximately 10 minutes, the fan will switch itself
off automatically.
Switching off
Touch the
symbol.
y
This immediately stops fan run-on.
Automatic mode
Switching on
Touch the
symbol.
#
1.
The fan will start at setting 2.
Touch the
symbol.
>
2.
The optimum fan setting is set automatically using a
sensor.
Switching off
Press the
or
button to switch off automatic mode.
>
#
The fan switches itself off automatically if the sensor
detects no further change in the air quality in the room.
Automatic mode can run for a maximum of 4 hours.
Sensor control
In automatic mode, the PerfectAir sensor in the
extractor hood detects the intensity of the cooking and
roasting odours. Depending on the setting of the
PerfectAir sensor, the fan automatically switches itself to
another fan setting.
Possible sensor settings:
Default sensitivity setting:
Lowest sensitivity setting:
Highest sensitivity setting:
If the sensor controller responds too strongly or not
enough, it can be changed accordingly:
Touch and hold the
1.
switched off. The setting will be displayed.
The sensor controller setting can be changed by
2.
touching symbols 1, 2, 3,
Take your finger off the
3.
„
(fan setting 3)
(fan setting 1)
‚
(fan setting
†
D
symbol when the fan is
>
or
C
D
symbol.
>
)
.
Hide quick links:
Advertisement
Table of Contents
