Measurement Settings - Nikon NPL-322 Instruction Manual

3 Getting Started

Measurement settings

To view the measurement settings,hold down
[MSR2]
Use
[^]
or
[<] [>]
Field
Target
Const (prism constant)
Mode
AVE (Average count)
Rec mode
Target field
If the measurement is started with the Target field set
to Prism, there is a dash "–" in front of the prism
constant.
If the measurement is started with the Target field set
to N-prism, there is a square bracket "]" in front of the
prism constant.
The symbol then constantly runs from left to right over the prism constant in the
display.
When an N-prism measurement is taken, the
appears in the status bar (above the battery icon).
Incorrect Target settings may result in measurements outside the precision and intervals specified for the
instrument.
If a prism target is aimed in the N-prism mode, the warning message "Signal High! → Try Prism Mode" will be
displayed because of the excessive light reflection.
A measurement made immediately after changing the target setting may take a longer time than usual.The
Target setting is used to apply better cyclic-error adjustment in distance measurement. It efficiently eliminates
multipath reflection.
5 2 Total Station NPL-322 Instruction Manual
for one second.
or to move the cursor between the fields. Use
[v]
to change the value in the selected field.
Values
•
•
–999 mm through 999 mm
•
•
0 (Continuous) through 99
One of the following:
•
•
•
[MSR1]
Prism
N-prism
Precise
Normal
MSR only
Confirm
ALL
icon
or