Daily Use - Drying Only - Electrolux EWW1696SWD User Manual

20 www.electrolux.com
Press the button
appliance again.
• After 5 minutes from the end of the
washing programme
Press the button
appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.

11. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
11.1 Drying setting
WARNING!
Make sure that the water
tap is open.
1. Press Marche/Arrêt for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme applicable for the items
to dry. The display shows the drying
indicator
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
11.2 Drying at automatic levels
The laundry can be dried at pre-defined
levels of dryness:
1. Press
display shows one of the dryness
level indicator:
• : IRON DRY level indicator for
cotton items
to activate the
to activate the
.
again and again until the
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
• : CUPBOARD DRY level
indicator for cotton, synthetic, silk
and wool items
• : EXTRA DRY level indicator
for cotton items
The display shows a time value,
calculated on the default load size. If the
amount of your laundry is more or less
than the default size, the appliance
adjusts automatically the time value
during the cycle.
2. Press to start the programme.
The display shows the door locked
indicator . The drying indicator
starts to flash.
You cannot set all dryness
levels for any type of
laundry.
11.3 Timed drying
The laundry can also be dried with a
manual timed drying:
1. Press again and again to set the
time value (see the «Programmes for
timed drying» table).
• The display shows 10 minutes.
Each time you press this
touchpad the time value increases
by 5 minutes.
• The display shows the set time
value: for example –
• After some seconds the display
shows a new time value:
appliance calculates also the
.
. The