Table of Contents
Advertisement
PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120 V, 60 Hz power outlet and turn on
the power switch on the rear of the unit . Only operate heater in upright position .
Insert two AAA batteries into the remote control before using (batteries not included) . *(Not all products
will include a remote control .)
Please note that infrared heaters do not heat like a traditional space heater . You should not expect infrared
heaters to blow hot air like a traditional space heater . Infrared heaters heat objects not air . Infrared
heaters are intended to supplement an already heated, insulated room . Square footage specifications
assume a single enclosed room not an entire home . Infrared heaters do not heat through walls, floors, and
are not intended to replace a main heat source . Infrared heat can take at least 24 hours to warm a room
but operate much more efficiently to maintain the desired temperature . Infrared heaters will not work
well in uninsulated unheated spaces like screened in porches, RV's, garages, unheated basements, etc .
TROUBLESHOOTING
PROBLEM
The heater does
not turn on .
The heater
displays an error
code "E1"
The heater
displays an error
code "E2"
POSSIBLE CAUSE
1 . The power cord is not plugged in .
2 . The electricity at the main fuse
box is not working .
3 . The battery in the remote control
is dead .
4 . The thermostat on the heater
is set lower than the room
temperature .
5 . The power switch in the back of
the unit is not in the ON position .
1 . The heater has overheated .
2 . Insufficient power to the unit
3 . The air filter is clogged .
4 . Insufficient air flow to the heater .
1 . Temperature sensor not
functioning properly .
CORRECTIVE ACTION
1 . Plug the power cord into an electrical
outlet .
2 . Check the electricity at the main fuse
box .
3 . Replace the batteries in the remote
control .
4 . Increase the thermostat temperature
on the heater for a higher heat setting .
5 . Switch the power switch to the ON
position .
1 . Unplug the heater from the wall, wait a
few seconds then plug the power cord
back in .
2 . Make sure the unit is plugged into
a dedicated 3-prong outlet, with no
extension cords or surge protectors .
3 . Clean the air filter located on the back
of the unit . see page 13 .
4 . Move the unit at least 3ft from the wall .
1 . Please contact technical support .
8
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the HT1216 and is the answer not in the manual?
Questions and answers
my HT1216UL heater has power, it was off for 2 days. when i try to turn it on it immediately shuts off, is there a reset button i can try
What is the part number for the tempature sensor
when i go to turn the heater on it immediately clicks off
The Life Smart HT1216 heater may turn off immediately when you try to turn it on due to overheating or insufficient power. If the heater displays an error code “E1,” it has overheated. To fix this, unplug the heater, wait a few seconds, and then plug it back in. If the issue persists, check if there is sufficient power to the unit.
This answer is automatically generated