Miele HR1724 Operating Instructions Manual page 72

Frequently Asked Questions
Problem
The browning is
uneven.
The oven lighting does
not turn on.
There is soiling in the
over after the Self Clean
program.
72
Possible cause and solution
The wrong temperature or shelf level was selected.
 There will always be a slight unevenness. If the
unevenness is great, check whether the correct
temperature and shelf level were selected.
That material or color of the bakeware is not suitable
for the oven mode selected.
 When using Surround, use matte, dark colored
pans. Light colored, shiny pans will not produce as
desirable results.
The halogen bulb needs to be replaced.

Danger of burns!
Make sure the heating elements are turned off and
allowed to cool completely.
The lamp cover may be damaged if it falls.
When removing the cover hold it firmly so that it
does not fall. Place a towel on the oven floor and
open door to avoid damage.
 Disconnect the appliance from the power supply.
 Loosen the bulb cover with the tool supplied at the
back of the frame.
 Do not touch the halogen bulb with bare fingers.
Observe the manufacturer's instructions.
Remove the halogen bulb.
 Replace it with a new halogen bulb (Sylvania
66740, 120 V, 40 W, G9, FS1).
 Press the bulb cover back into place.
 Reconnect the oven to the electrical supply.
The Self Clean program burns off soiling in the oven
and leaves it as ash.
 Using a soft sponge, warm water and liquid dish
soap remove the ashes.
If coarse soiling remains, start the Self Clean
program again with a longer duration.