Installing The Unit - Kenwood DDX9905S Instruction Manual

Connection/Installation
Ñ
Installation procedure
1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the speaker wires of the wiring
harness.
4) Connect the wiring harness wires in the
following order; ground, battery, ignition.
5) Connect the wiring harness connector to the
unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Perform the Initial Setup.
See Initial setup (P.7).
90

Installing the unit

Ñ
Non-Japanese cars
(Except DDX9705S)
Ñ
Japanese cars
6 or 7
Car Bracket
NOTE
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
Ñ
Trim plate (Except DDX9705S)
1) Attach accessory 8 to the unit.
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.
6 or 7
8