Smart Stove Wifi Connection - Mr. Heater Grand Teton PS20WTS Owner's Manual

MINIMIZING CREOSOTE FORMATION
See "MAINTENANCE" on page 18 for an explanation
of Creosote formation and removal. To slow the build
up of creosote within your chimney burn only the
recommended fuel, see page 13.
DISPOSAL OF ASHES
CAUTION: EMBERS MAY BE OBSCURED BY ASH.
HANDLE ASH WITH TOOLS SUFFICIENT FOR
FIRE TENDING, NEVER DIRECTLY WITH YOUR
HANDS. WEAR FIRE RETARDANT CLOTHING
AND PROTECTIVE EYEWARE.
Ashes should be placed in a metal container with a
tight fitting lid.
1. Other waste shall not be placed in ash containers.
2. The closed container of ashes should be placed
on a noncombustible floor or on the ground, well
away from all combustible materials, pending final
disposal.
3. Wood mineral residue (approximately 1-2%) remains
in the ash and is an excellent natural fertilizer
product for all garden plants. Before disposing ashes
of by burial in soil or otherwise locally dispersed,
they should be retained in the closed container until
all any and all cinders have thoroughly cooled and
should also be "quenched" with water.

SMART STOVE WIFI CONNECTION

This stove can be monitored, controlled, and
programmed by using the smart stove app by NHHATC
which is available for iOS or android device through
the app store.
Grand Teton Wood Pellet Fire Stove
Step 1. Download the Smart Stove app by NHHATC.
Step 2. Open the Smart Stove app. The app opens, by
default, to the "Register" screen. Click on the
"Register" button.
Step 3. Enter your email address in the "Email" field
and click the "Get Verification Code" button.
Step 4. Enter the verification code that was emailed to
you in the "Enter Verification Code" field.
Step 5. Now you can set a unique password for your
device in the "Set Password" field and hit the
"Done" button.
Step 6. If you have no other wifi enabled devices
already added to this app there will be a large
"Add Device" button in the center of the screen
which you can select. Otherwise, select the +
symbol in the top right of the screen.
Step 7. Make sure that your device is connected to the
wifi network which you want the stove to be
connected to.
Step 8. Make sure that the wood pellet fire stove is
plugged into an electrical outlet and can be
powered on.
Step 9. Follow the directions on the screen by pressing
and holding the connection button for 3
seconds on the back bottom of the stove
as illustrated in the figure below. Once you
observe the desired blinking pattern on the
indicator light, press the confirmation button at
the bottom of the screen.
Power Cord
Figure 15 Display Panel Back/LED Light
Step 10. Enter the password for the wifi network
so that the stove can connect to the wifi
network.
Step 1 1. The stove will begin pairing with the device
running the application through the wifi
network. This process may take a few
minutes.
15
Operating Instructions and Owner's Manual
LED Light
Button