Sealey AK2962 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment,

make sure you know where the nearest fire extinguisher is.
WARNING! Always wear approved eye / face protection when operating the torch.

WARNING! DO NOT use the torch if you notice that it is damaged or if there could be a gas leak from it.

WARNING! Butane gas is extremely flammable, handle with care.

WARNING! Always point the torch away from the eyes and body when igniting and during operation.

WARNING! DO NOT put the torch down when it is lit, DO NOT leave it unattended.

WARNING! The flame is not easily visible in bright daylight.

WARNING! Ensure the flame is completely extinguished after use. DO NOT use water to cool the torch down.

WARNING! Only use in a well ventilated area.

DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard. Keep

flammable material away from the torch when operating.
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.

DO NOT hold any workpiece by hand.

DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.

DO NOT operate the torch if it is damaged as this may cause failure and/or possible personal injury.

DO NOT touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.

DO NOT allow children to operate the torch.

After use, allow the torch to cool before storing it.

When not in use, store away from direct sunlight in a safe, dry, childproof location.

DO NOT store at over 40°C, such as in a car in hot weather.

2. INTRODUCTION
High quality, lightweight torch kit. Suitable for heating, soldering and shrinking. Powered by butane (lighter fuel) and features a piezoelectric ignition
switch. Supplied with an anti-ignition cap and features gas/flame control. Torch is fitted with a retractable stand.
3. CONTENTS
Soldering torch
Hot Air Nozzle
Deflector Nozzle
Soldering Head
AK2962
© Jack Sealey Limited
INSTRUCTIONS FOR:
PROFESSIONAL SOLDERING/HEATING KIT
AK2962
MODEL No:
3 x Soldering Tips
Hot Knife
Soldering Sponge
Solder
Original Language Version
AK2962 Issue: 1 - 11/08/14