Table of Contents
Advertisement
Auger Belt Replacement
WARNING: Run the engine com-
pletely dry of gasoline before tipping
snowthrower.
To remove and replace your snow thrower's auger belt,
proceed as follows:
1. Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws. See
Figure 6-4.
Figure 6-4
Figure 6-5
Figure 6-6
2. Carefully pivot the snow thrower up and forward so
that it rests on the auger housing. Remove the frame
cover from the underside of the snow thrower by
removing self-tapping screws which secure it. See
Figure 6-5.
3. Roll the auger belt off the engine pulley. See Figure 6-6.
4. a. Loosen and remove the shoulder screw which
acts as a belt keeper. See Figure 6-7.
b. Unhook the support bracket spring from the
frame.
5. Remove the belt from around the auger pulley, and
slip the belt between the support bracket and the
auger pulley. Reassemble auger belt by following
instructions in reverse order. See Figure 6-8.
NOTE: Repeat the auger control test on page 11 before
operating the snowthrower.
NOTE: Do NOT forget to reinstall the shoulder screw
and reconnect the spring to the frame after installing a
replacement auger belt.
Figure 6-7
Figure 6-8
15
6
Maintaining
Your Snow
Thrower
NOTE: Although
multi-viscosity oils
(5W30, 10W30 etc.)
improve starting in cold
weather, these multi-
viscosity oils also result
in higher oil consump-
tion when used above
32ºF (0ºC). Check your
snow thrower's engine
oil level more frequently
to avoid possible
engine damage from
running low on oil.
IMPORTANT
NEVER replace the
auger shear pins with
standard pins. Any
damage to the auger
gearbox or other com-
ponents, as a result of
doing so, will NOT be
covered by your snow
thrower's warranty.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Two Stage Snow Blower and is the answer not in the manual?
Questions and answers
How do you get the belt back on to the pulleys?
To reinstall the belt on the pulleys of a White Outdoor Two Stage Snow Blower, follow these steps in reverse order of removal:
1. Slip the belt between the support bracket and the auger pulley.
2. Place the belt around the auger pulley.
3. Hook the support bracket spring back onto the frame.
4. Reinstall the shoulder screw, which acts as a belt keeper.
5. Roll the belt back onto the engine pulley.
6. Reattach the plastic belt cover using the two self-tapping screws.
7. Perform the auger control test before operating the snow thrower.
Ensure the shoulder screw is properly reinstalled and the spring is securely connected to the frame.
This answer is automatically generated
Hi, please help. I have a WHITE two-stage snow thrower Model # 31AH6WFG790. The augur doesn't throw heavier snow up the shute Can I adjust the augur belt on my blower? Thank you Bob
Yes, you can adjust the auger belt on a White Outdoor two-stage snow blower. To do this, follow these steps:
1. Remove the plastic belt cover on the front of the engine by removing the two self-tapping screws.
2. Roll the auger belt off the engine pulley.
3. Loosen and remove the shoulder screw acting as a belt keeper.
4. Unhook the support bracket spring from the frame.
5. Remove the belt from around the auger pulley and slip it between the support bracket and the auger pulley.
6. Reassemble by following these steps in reverse order.
After replacing the belt, reinstall the shoulder screw and reconnect the spring to the frame. Also, perform the auger control test before operating the snow thrower.
This answer is automatically generated