Table of Contents
Advertisement
8. ADJUSTING THE WATER SOFTENING SYSTEM
(Select Models)
Cleaning, rinsing and drying performance of your dishwasher will increase when
water softening system is adjusted properly.
Adjust the new water hardness level according to the Water hardness level
instruction in this booklet.
Use the test strip supplied with the product according to the steps given below to
determine hardness level of your supply water.
a
b
Remove the test
Turn on the tap and
strip from the
let the water run for
packet.
about a minute.
After determining hardness level of the supply water:
1. Turn on the machine, press Time Delay and P+/P keys simultaneously. After
the countdown (3,2,1) is displayed keep the keys pressed for a while.
2. Press P+/P key to activate the (r..) position.
3. Using Time Delay key, adjust water hardness level according to the hardness of
the supply water. See "Water hardness level adjustment table" for correct setting.
4. Press On / Off key to save the setting.
Water hardness level adjustment table
Hardness
Grains Per
Level
Gallon (gpg)
0th Level
0-14
1st Level
15-22
2nd Level
23-37
3rd Level
38-46
4th Level
47-58
5th Level
59-154
If the hardness level of the supply water is above 154 gpg (grains per gallon) or if
you are using well water, then it is recommended to use water purification devices
and special filters.
If the hardness level of the supply water is below 22 gpg, there is no need to use
salt in your dishwasher. If this is the case, "No Salt Warning Indicator" (if any)
illuminates continuously on the panel of your machine.
If the water hardness level adjustment is set to level 1, the "No salt warning
indicator" will illuminate continuously although it is not necessary to use salt. If
c
1 min.
1 Second
Hold the test strip in
the water for about
a second.
German Water
French Water
Hardness °dH
Hardness °dF
0-4
0-8
5-7
9-13
8-12
14-22
13-15
23-27
16-19
28-34
20-50
35-90
d
Remove the test
strip from the water
and shake it.
Water Hardness Level Indicator
Press the Time Delay key to switch the water hardness level
to position 1. (r1)
Press the Time Delay key to switch the water hardness level
to position 2. (r2)
Press the Time Delay key to switch the water hardness level
to position 3. (r3)
Press the Time Delay key to switch the water hardness level
to position 4. (r4)
Press the Time Delay key to switch the water hardness level
to position 5. (r5)
25
USA
e
f
1 Minute
Wait for 1 minute.
The test strip shows
you the hardness
level.
Advertisement
Table of Contents
