Advertisement
OPERATING MANUAL
S.M.D. REWORK STATION
Thank you for choosing XYTRONIC LF-852D S.M.D. Rework Station. This tool is
specially designed for soldering, desoldering Surface Mount Devices with temperature
controlled hot air. When used in conjunction with our 628 Preheat system, the 852D
will achieve marked improvements in quality and efficiency of your rework tasks.
Please read the operating manual carefully to maximize the advantages of using your
new LF-852D Hot Air rework station and keep this manual readily accessible for future
reference.
FOR
LF-852D
HOT-AIR
Advertisement
Table of Contents
Related Manuals for Xytronic LF-852D
Summary of Contents for Xytronic LF-852D
- Page 1 Please read the operating manual carefully to maximize the advantages of using your new LF-852D Hot Air rework station and keep this manual readily accessible for future reference.
- Page 2 INTRODUCTION This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with appliance. Failure to observe the safety regulation will result in a risk of life and limb.
- Page 3 2. Do not pressure the AC power cord. Be sure the work area is well ventilated. 3. Do not bump, hit, pour water/liquids or otherwise subject the heating surface to physical shock. This may damage the heater. 4. To isolate the equipment from the mains before commencing repairs or making any maintenance to avoid electric shock.
-
Page 4: Product Features
PRODUCT DESCRIPTION The temperature controlled Hot-Air LF-852D SMD rework station built in an intelligent microcomputer chip which is specially designed for the present lead free SMD chips such as SOIC, CHIP, QFP, PLCC, BGA etc reworks to meet RoHS requirement. -
Page 5: Specifications
Model LF-852D REWORK STATION Power Voltage 100-120Vac 60Hz 220-240Vac 50Hz Power Consumption (Max) 600W Pump Diaphragm 115Vor120V 230V or 240V Air Flow 1.5L-40L /Min Temperature range 212℉-896℉ 100℃-480℃ Dimensions 283(W)*120(H)*190(D) mm Fuse (Fast type) SPECIFICATIONS BRIEF INTRODUCTION OF PANEL FUNCTIONS: Front panel ○... - Page 6 Caution High Temperature Operation Do not use the LF- 852D near ignitable gases, or other inflammable materials. Both nozzle and hot air are extremely hot and can cause burns. Never touch the nozzle and heater assembly or allow the hot air to blow against your skin. Initially, the iron may emit white smoke, but this will soon dissipate.
- Page 7 4. Press “▲”or “▼” key to choose the desired air flow on the right side of the front panel. The speed will change 5 degrees by pressing the keys “▲” or“▼” at a time. 5. After adjusting the air flow and temperature and wait for the temperature to stabilize for a short period of time.
- Page 8 drop or damage it. 3. Remove the Heating Element. Disconnect the terminals and remove the heating element. 4. Insert a new Heating Element. Handle the new heating element with care and do not touch the wire leads. Insert a new heating element and reconnect the terminals. Reconnect the ground wire after replacing the element.
Need help?
Do you have a question about the LF-852D and is the answer not in the manual?
Questions and answers