Pto Shaft Guard Installation; Tilt-Up Roller Wheel Installation; Mower Deck Installation On Tractor; Deck Installation - Walker T27i Operator's Manual

Assembly Instructions

PTO Shaft Guard Installation

Position the shaft guard as shown and mount with
two (2) 1/4-20 x 1/2 in. bolts.

Tilt-Up Roller Wheel Installation

Mount the two (2) tilt-up roller wheels on the brack-
ets on the rear skirt of the deck housing using the
P/N 8490 axle bolt, 3/8 in. wave spring washer and
3/8-16 in. Whiz locknut. Tighten the axle bolt until
the wheel rolls freely, but is not loose.
Tilt-Up Spring and Roller Wheel
Installation on Rear Discharge Deck

Mower Deck Installation on Tractor

Deck Installation

1. Lightly grease each deck support arm (2) on the
tractor. Refer to Mower Deck Installation pho-
to for location of deck support arm.
2. Engage the deck carrier frame tube sockets on
the tractor support arms (refer to Discharge
Chute and PTO Shaft Guard Installation pho-
to for socket location), slide the deck onto the
support arms approximately 3 in. (76 mm).
3. Retract the spring-loaded quick disconnect ring
on the PTO Coupler and insert the Coupler In-
stallation Tool (provided in Owner's Packet) as
shown in the photo below.
NOTE: The Coupler Installation Tool is provided
for convenience, but is not required for installa-
tion.
22
Attach Spring
Roller Wheels
Coupler
Installation Tool
PTO Coupler
Tube
PTO Coupler Installation Tool
4. Reaching under the tractor, slide the PTO cou-
pler tube onto the deck drive shaft (align arrow
decals), then install the coupler quick discon-
nect onto the tractor PTO drive shaft.
IMPORTANT: When installing the DS52 or
DS62 Mower deck, make sure to retract the
dolly wheel after mounting the deck on the trac-
tor.
Arrows on Shaft and Tube
(Used to Align When Sliding Together)
PTO Connection
Grease Deck
Support Arms
Mower Deck Installation
(PTO Shaft Connection)
5. Remove Installation Tool from quick disconnect
ring and make sure the ring has "snapped" se-
curely on the spline shaft.
IMPORTANT: DO NOT operate tractor with
Coupler Installation Tool installed.
Retract Spring-Loaded
Quick Disconnect Ring