Boil-Dry Protection - Kenwood ZJM811 Instructions Manual

before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
underside of your kettle.
Important - UK only
The wires in the cord are coloured
l
as follows:
Green and Yellow = Earth
Blue = Neutral
Brown = Live.
The appliance must be protected by
l
a 13A approved (BS1362) fuse.
WARNING: THIS APPLIANCE
l
MUST BE EARTHED.
Note:
For non-rewireable plugs the fuse
l
cover MUST be refitted when
replacing the fuse. If the fuse
cover is lost then the plug must
not be used until a replacement
can be obtained. The correct fuse
cover is identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut
l
off it must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first time
1 Wrap any excess cord around the
bracket e on the underside of the
powerbase.
2 Fill to 'MAX', boil, then pour the
water away. Repeat 3 times.
key
a lid
b on/off switch
c 360° powerbase
d power on light
e cord wrap
f filter
A water level gauge
to use your kettle
1 Fill the kettle by removing the lid. The
water level must be between 'MAX'
and 'MIN' (250mls) on the water
level gauge inside the kettle (A).
If you live in a hard water area we
l
recommend that you use filtered
water in order to maintain the
appearance and efficiency of your
kettle.
Be economical: do not boil more
l
water than you need.
To improve the quality of your drinks
l
always use fresh water.
Empty the kettle after each use.
l
Rinse out with fresh water if the
l
kettle has not been used for more
than 2 days.
2 Check the lid is fitted correctly.
3 Plug in and switch on. The power on
light d will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
Note - To interrupt the boiling
ensure that the switch is
in the off position before
removing from the powerbase.
If you experience problems
l
with your kettle switching
on and off during use or
switching off before boiling,
check that the flat element
is free from scale - see
"descaling".
Your kettle is fitted with a filter to
l
hold back limescale particles.
If you find drops of water under
l
your kettle, do not worry - it is just
condensation.

boil-dry protection

If you switch on with too little water,
l
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
4