Table of Contents
Advertisement
SECURITY SYSTEM ONLY
REMOTE CAR STARTER ONLY
SECURITY SYSTEM AND REMOTE CAR STARTER
AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES
FTX900
Model : FTX900
FCC ID : 2ACKU-R1W01FSS
IC : 12084A-R1W01FSS
Manufacture : FORTIN
DESIGNED & ENGINEERED IN CANADA
DOC#: 68381 - REV:G 20170719 © 2017 ALL RIGHTS RESERVED
User Guide
Advertisement
Table of Contents
Related Manuals for Fortin FTX900
Summary of Contents for Fortin FTX900
- Page 1 REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES FTX900 User Guide Model : FTX900 FCC ID : 2ACKU-R1W01FSS IC : 12084A-R1W01FSS Manufacture : FORTIN DESIGNED & ENGINEERED IN CANADA DOC#: 68381 - REV:G 20170719 © 2017 ALL RIGHTS RESERVED...
-
Page 2: Table Of Contents
TABLE DES MATIÈRES TABLE OF CONTENTS TABLE OF CONTENTS ......................... 2 INTRODUCTION ..........................2 CAUTION - WARNING ......................... 3 NOTE ................................3 INDUSTRY CANADA USER NOTICE ...................... 3 GOVERNMENT REGULATIONS ..................................3 USING THE REMOTE CONTROL ......................4 REMOTE-STARTING ..........................5 REMOTE-STARTING THE VEHICLE ....................... -
Page 3: Caution - Warning
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • ensure that the vehicle is parked in a safe and responsible manner. • ensure that the vehicle is not remotely started indoors (garage, underground parking). •... -
Page 4: Using The Remote Control
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with the Industry Canada Radio Standards Specifi cation RSS 210. -
Page 5: Remote-Starting
See : REMOTE LOCKING AND UNLOCKING, page 11 LOCKED Until the THE RE- BLUE LED The BLUE LED will come on Press and release turn on. MOTE Whenever a button is pressed FUNCTION and then press simultane- when the remote is LOCKED. ously LOCK and FUNCTION UNLOCKED... -
Page 6: Accessory Preset
ACCESSORY PRESET Heater & Heated Seat(s): When leaving the vehicle it is recommended that the driver pre-set the climate controls in preparation for a later Remote-Start. When the vehicle Remote- Starts, the current (or last) setting for the climate controls, windshield wipers (and other accessories) will be used. -
Page 7: Driving Off
STEP 6 Exit the vehicle and close all of the doors. The Remote-Starter will stop running once all the doors are closed. METHOD 2 This method must be programmed by the installer during installation. THIS METHOD WILL ACTI- VATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE VEHICLE. AUTOMATIC AC- TIVATION: The vehicle must be running. -
Page 8: Idle Mode (Manual Transmission)
to reset this timer. To activate Idle Mode (automatic transmission) proceed with the following steps: STEP 1 With the key in the barrel at the ignition (ON/RUN) position and the en- gine running, press the START button until the parking lights turn on. STEP 2 Turn the key to the OFF position and remove the key from the ignition barrel. -
Page 9: Turbo Mode (Automatic Transmission)
TURBO MODE (AUTOMATIC TRANSMISSION) Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger to cool down. To activate Turbo Mode (automatic transmission) proceed with the follow- ing steps: STEP 1 With the engine already running, press the remote START button until... -
Page 10: Cold Start Timer Mode
enabling/disabling Valet Mode uses the remote transmitter instead of the valet switch indicated in the preceding section. To enter Valet Mode using the remote transmitter proceed with the following steps: STEP 1 Press and release the FUNCTION button, within 12 seconds simultaneously press and hold the LOCK and UNLOCK buttons for 1 second. -
Page 11: Remote Starting Options
Aux 2 : Passenger side sliding door (if installed). Press and relase the FUNCTION button (the remote LED fl ashes slowly white) within 12 seconds press the UNLOCK button. Note: The function of the auxiliary outputs may vary depending on the vehicle and the installation. In most cases these outputs are not used, and in some cases they may be used to control other features such as the power windows, sunroof, or heated seats. -
Page 12: Active Or Passive Arming
To LOCK the doors and ARM the Alarm: The parking light will fl ash once and the LED will turn ON to confi rm the signal. The Starter-Kill will activate preventing the Press the LOCK but- vehicle from being started with the key. If LOCK is pressed again ton for 0.5 second. -
Page 13: Alarm Activity
ALARM ACTIVITY The following characteristics enhance your vehicle’s security : If the Alarm system is active and the horn/siren is sounding : • Press the UNLOCK button ONCE to stop the alarm sound. The Alarm will remain active and will immediately resound if a zone is (re)triggered. -
Page 14: Failed Remote-Start
• Hold the transmitter at shoulder height or hold it against your chin so your body acts as a larger antenna. • The operating range will be somewhat poorer on vehicles equipped with a factory alarm or key- less entry system. FAILED REMOTE-START There are several different installation factors and devices that must work together in order for your vehicle to Remote-Start properly.
Need help?
Do you have a question about the FTX900 and is the answer not in the manual?
Questions and answers