Table of Contents
Advertisement
The external monitor displays nothing.
Make sure that the monitor is turned on.
Make sure that the monitor's signal cable is properly connected.
Check if the Setup item Display Mode on the Main menu of the
SCU program is configured correctly.
Switch the display to the monitor by pressing
display through the settings in Display Properties.
Simultaneous display/multi-display does not work.
Make sure that you turn on the external monitor before turning on
the computer.
Check if the Setup item Display Mode on the Main menu of the
SCU program is configured correctly.
Fn
F9
Press
+
display options.
Floppy Disk Drive Problems (on optional docking station)
The Floppy Disk Drive In-use Indicator stays on.
Make sure that the floppy disk is not physically damaged.
Make sure that the floppy disk is inserted correctly.
The disk drive cannot write to a floppy disk.
Make sure that the floppy disk is formatted.
Make sure that the floppy disk is not write-protected.
Make sure that you are writing to the correct drive.
Make sure that there is enough space left on the floppy disk.
Make sure that the floppy disk is not physically damaged.
Make sure that the floppy disk is formatted.
Make sure that you are reading the correct drive.
Troubleshooting
or use Windows' Display properties to select the
Fn
F9,
+
or change the
8-7
Advertisement
Table of Contents
