Taking The Engine Out Of Operation For More Than 12 Months - ABB HT846728 Operation Manual

Operation Manual / TPS44-H.. - TPS52-H..
12 Mothballing the turbocharger / 12.2 Taking the engine out of opera-
tion for more than 12 months
Clean all parts.
u
Coat the plain surfaces of steel and cast parts with anti-corrosive oil.
u
Fit turbocharger completely.
u
CAUTION
Rotation of the rotor in the stack draught
The rotor can rotate in the stack draught. If the bearings are not lubricated,
this can result in wear.
Install blind flange between gas outlet casing and exhaust gas pipe.
u
12.2 Taking the engine out of operation for more than
12 months
If the engine is taken out of operation, the following variants are possible with regard to the
turbocharger:
¡
Turbocharger remains attached to the engine
¡
The casings of the turbocharger remain attached to the engine, the rotor and bearing
parts are dismantled by an ABB Turbocharging Service Station and stored separately
¡
The turbocharger is completely removed, either as a whole unit or in individual parts
For the measures always necessary for preparing the turbocharger parts for mothballing,
see section Taking the engine out of operation for up to 12 months, subsection Preparations
for mothballing.
If the turbocharger remains attached to the engine, see section
eration for up to 12 months
If the complete turbocharger is removed or the turbocharger is assembled again from the
individual parts:
Seal all openings of the turbocharger with paraffin paper and wooden lids.
u
Only dry rooms with 40 ... 70 % atmospheric humidity, in which no water condensation can
form, are suitable as storage locations.
State of the mothballed turbocharger
Check the turbocharger parts annually for corrosion.
u
If there are signs of rust: Thoroughly clean parts and renew corrosion protection.
u
© Copyright 2021 ABB. All rights reserved.
→94, subsection Rotor turning in stack draught.
HZTL4037_EN
Taking the engine out of op-
Rev.G June 2021