Advertisement
Procedure 3A → 3B → 3C → 3D → 3E → 3F
Ref. No. 3F
Procedure 3A → 3B → 3C → 3D → 3E → 3F→
Ref. No. 3G
3G
Assembly of the Adjusting Screw and the Clutch Handle.
for EY7940
1. Hold the driving block with the click spring on top, and align the
mark of adjusting screw with the bottom of the clutch case.
NOTE:
Make sure that the adjusting screw has its own correct direction
for proper assembly. Failure to do so, the clutch handle does not
rotate properly.
2. Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
3. Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
(Align the projection of clutch handle on bottom.)
Attachment of the H/L change handle.
1. Insert the both side of handle spring into the groove of Ring gear
A.
12
Advertisement
