Advertisement
Advertisement
Related Manuals for Belling GHU573
Summary of Contents for Belling GHU573
- Page 1 Belling Gas Hob GHU573 - GHU573T GHU70GE - GHU70TGE - GHU70GC GHU70TGC - GHU60GC INSTALLATION AND USER INSTRUCTIONS Note: This appliance is supplied for use with Natural Gas and can be converted to LPG by a suitably qualified engineer with the kit supplied...
-
Page 2: Table Of Contents
CONTENTS 1. Introduction 2. Your Belling Hob 3. Cleaning 4. Safety Instructions 5. Installation Instructions 6 - 9 6. User Instructions 7. Fault Finding Guide 8. Calling for Service Back Cover This appliance conforms to the following EEC Directives: Low Voltage Equipment... -
Page 3: Introduction
If you have any problems with installing, operating, or cooking with your Belling hob, please check through these instructions thoroughly to make sure that you have not missed anything. If you still need help, then... -
Page 4: Your Belling Hob
Check parts are reassembled correctly by lighting the burners and allowing to dry out. PLASTIC Control knobs. Wipe with a cloth wrung out in hot soapy water. STAINLESS STEEL Cloth wrung out in hot soapy water. Alternatively use a propriety stainless steel cleaner obtainable from Belling Spares Team call 0870 458 9961... -
Page 5: Safety Instructions
It is in your interest and that of safety to ensure compliance with the law. 2. Repairs or servicing of this product must only be carried out by an authorised Belling service agent using only approved parts. -
Page 6: Installation Instructions
The safety and automatic adjustment devices of the appliance may only be modified by an authorised Belling service agent. The installation of this gas hob must comply with the standards in force. This appliance is not connected to a flue for discharge of the combustion products; therefore, it must be connected in compliance with the above mentioned installation rules. - Page 7 5. INSTALLATION INSTRUCTIONS UNPACKING THE APPLIANCE Remove all packaging before use and check to make sure that the appliance is in perfect condition. If you have any doubts do not use the appliance and call your supplier. Some parts on the appliance are protected by a plastic film. This protective film must be removed before the appliance is used.
- Page 8 5. INSTALLATION INSTRUCTIONS GAS CONNECTION The appliance’s gas inlet fitting is a 1/2” male threaded cylindrical gas type in accordance with the ISO 228-1 standards. Make the connection using rigid pipe. ELECTRICAL CONNECTION This appliance must be connected by a competent person, using fixed wiring via a double pole switched fused spur outlet with a fuse rating of 3amps, and with a contact separation of at least 3mm in all poles.
- Page 9 5. INSTALLATION INSTRUCTIONS This appliance is adjusted for NATURAL GAS at 20mbar ONLY. The hob is suitable for conversion to Liquid Petroleum Gas BUTANE (G30) at 28-30 mbar and PROPANE (G31) at 37 mbar by the following procedure using the kit supplied. Replace the injectors with the corresponding injector from the table on page below.
-
Page 10: User Instructions
6. USER INSTRUCTIONS 1. To light the hotplate push in the appropriate control knob and turn anti-clockwise to the large flame symbol (fig. 9). 2. Keep the knob depressed until the burner lights. 3. Turn the tap to the required setting. NOTE: Matches can be used to light the burners in the event of a power failure. -
Page 11: Fault Finding Guide
7. FAULT FINDING GUIDE Check the guide below if there is a problem with your hob. UNEVEN OR YELLOW FLAME RATHER THAN BLUE. Switch off and check the following points: 1. Are the burners fitted correctly? 2. Are the holes in the burner clear? 3. -
Page 12: Calling For Service
8. CALLING FOR SERVICE Please consult your retailer in the first instance. If you experience difficulty contact Belling Appliances, After Sales Division. Remember that you may be charged for the visit (even during the guarantee period) if nothing is found to be wrong with your appliance, so always check to make sure that you have not missed anything.
Need help?
Do you have a question about the GHU573 and is the answer not in the manual?
Questions and answers