Cold Water Connection; Start Of Dishwasher - Parmco PD6-PIT-1 Installation And Operating Instructions Manual

Cold Water Connection

WARNING!
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides along the
adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned
either to the right or the left sides to facilitate proper installation.
How to Drain Excess Water From Hoses
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly into the sink. It will
be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and lower than
the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure that the water
inlet hose is not squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose. It must be no longer than 4 metres,
otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avoid kinking or squashing it. The top of the hose must be less than 1000mm.

Start of Dishwasher

The following things should be checked before starting the dishwasher.
The dishwasher is levelled and fixed properly
+
The inlet valve is open
+
There is no leakage at the connections of the hoses
+
The power plug is fitted correctly
+
The power is switched on
+
The inlet and drain hoses are not kined
+
All packing materials and printings are taken out of the dishwasher
+
Attention:
After installation, please make sure to retain this manual.
The content of this manual is very helpful to users.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place. If the water pipes are new or have not been used for
an extended period of time, let the water run to make sure that the water is clear. This
precaution is needed to avoid the risk of the water inlet being blocked and damaging
the appliance.
Please close the hydrant after using.
18