Table of Contents
Advertisement
POWER (GND/REM/+12V)
j
Connect +12V DC power cable, ground wire and remote
•
wire.
Fuse
k
SPEAKER OUTPUT
l
Connect to subwoofers.
•
2. Installation
Installation
You can mount the amplifier either under a seat or on the rear tray.
Note
•
To avoid interference, do not place the amplifier too close to the car audio or
antenna.
•
The supplied mounting screws are 14mm long. Make sure that the mounting
board is thicker than 14mm.
1
Place the unit on the location for installation.
2
Mark the positions of the four screw holes.
3
Drill the holes with driller of approximately
3mm in diameter.
4
Mount the unit with the supplied screws.
Advertisement
Table of Contents
