Summary of Contents for smart home ADC-V522IR
- Page 1 Indoor Infrared Camera Installation Manual Installation Support: (877) 998-1457 AAA.com/SmartHome-Install...
-
Page 2: Pre-Installation Checklist
• Login and Password for the Alarm.com account to which you will add the camera Note: There are three options for connecting the ADC-V522IR to the network: Ethernet Mode, Wi-Fi Protected Setup (WPS) Mode, and Access Point (AP) Mode. ADC-V522IR Installation Guide... -
Page 3: Ethernet Mode
“ALARM (XX:XX:XX)” where XX:XX:XX is in its MAC address to begin adding the camera. the last six digits of the ADC-V522IR’s MAC address, The camera’s MAC address is located on the back which is located on the back of the ADC-V522IR. - Page 4 The LED will be solid green when the connection is complete. Add the device to the account by either selecting the account in MobileTech OR by using a web browser and entering the following URL: www.alarm.com/addcamera ADC-V522IR Installation Guide ADC-V522IR Installation Guide...
- Page 5 You can now power down the camera and install it in its Local network connection only, no internet final location using the included hardware. Solid Red | No network connection No local network or internet connection Flashing Red | System booting Camera is booting (Continued) ADC-V522IR Installation Guide ADC-V522IR Installation Guide...
-
Page 6: Troubleshooting
If already installed, the camera may need to be removed from the Alarm.com account and re- added after a factory reset. To perform a factory reset, push the WPS button and release when flashing Green and Red (about 15 seconds). ADC-V522IR Installation Guide ADC-V522IR Installation Guide...
Need help?
Do you have a question about the ADC-V522IR and is the answer not in the manual?
Questions and answers