Fujitsu UTY-VBGX Instruction Manual page 150

BACnet Gateway for VRF System
3. Object BACnet name: Signal's descriptive name that identifies the signal.
4. BACnet type: Type of BACnet object.
5. Object Instance: BACnet object instance. This can be a fixed number or a formula for the identification
of each element.
6. Units: Units applied to each object.
7. NC: Notification Class. Set the Notification Class added in the Cofiguration tab.
8. State text configuration: Enums the State text to be shown.
9. Relinquish default value: Indicates the current relinquish default value for this object.
10. COV: Sets the COV increment value for this object.
11. #: Internal gateway address for each register.
12. Device: FGL device number associated to this register.
a) Edit Columns: Enables or disables visible columns.
b) Export: Exports the current configuration.
c) Check table: Checks the current configuration to make sure.
Some of the columns above need to be enabled to be shown. Click "Edit columns" to enable.
8.6 Receive/Send
Send or receive the current configuration of the gateway.
IMPORTANT: It is required that the ethernet link of this gateway is established and active, in order to send
and configure the IP addresses. Otherwise, IP addresses will not be set by the "Send".
Figure 8.11 Send and receive options
Copyright© 2021 Fujitsu General Limited - All rights reserved
INSTRUCTION MANUAL r1.4.0 eng
150/159