Related Manuals for Philips HTS3111/05
Summary of Contents for Philips HTS3111/05
- Page 1 Register your product and get support at www.philips.com/welcome HTS3111 User manual...
-
Page 3: Table Of Contents
Contents Notice Compliance Mains fuse (UK only) Trademarks Important Safety Product care Disposal of your old product and batteries Contact us Your SoundBar Main unit Remote control Connect your SoundBar Connectors Use your SoundBar Before you start Play audio from TV or other devices Adjust the volume Choose your sound Apply factory settings... -
Page 4: Notice
Notice Compliance This product is in compliance with the essential requirements and other relevant provisions of Directives 2006/95/EC (Low Voltage), 2004/108/ EC (EMC). Mains fuse (UK only) This product is fitted with an approved moulded plug. Should it become necessary to replace the mains fuse, this must be replaced with a fuse of the same value as indicated on the plug (example 10A). -
Page 5: Important
Secure the wall mount to a wall that can support the combined weight of the product and the wall mount. Koninklijke Philips Electronics N.V. bears no responsibility for improper wall mounting that results in accident, injury or damage. -
Page 6: Product Care
If you have problems using this product, register your product and get support at www.philips.com/ welcome. If you contact Philips, you will be asked for the model and serial number of your product. The model number and serial number are on the back or bottom of your product. -
Page 7: Your Soundbar
Your SoundBar Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your SoundBar at www.philips.com/welcome. Main unit (Standby-On) • Switch the SoundBar on. • When the SoundBar is on standby, the standby indicator is red. - Page 8 SURROUND • Switch to DVS mode or stereo mode. • Press and hold to set night mode. TREBLE +/- Increase or decrease treble. VOL +/- Increase or decrease volume. BASS +/- Increase or decrease bass. MUTE Mute or restore volume. Replace battery Warning •...
-
Page 9: Connect Your Soundbar
Connect your SoundBar This section helps you connect your SoundBar to a TV and other devices. For information about the basic connections of the SoundBar and accessories, see the Quick start guide. Note • Refer to the type plate at the back or bottom of the product for identification and supply ratings. -
Page 10: Use Your Soundbar
Use your SoundBar This section helps you use the SoundBar to play audio from connected devices. Before you start Check that you make the necessary connections. Play audio from TV or other devices Press the Source buttons to select the audio output of the connected device. -
Page 11: Apply Factory Settings
Apply factory settings You can reset your SoundBar to the default settings programmed at the factory. In AUX mode, press TREBLE+, VOL-, and BASS+ within three seconds. » When the restore factory settings process is complete, the standby indicator blinks five times. Your SoundBar automatically switches off and back on again. -
Page 12: Product Specifications
Product specifications Note • Specification and design are subject to change without notice. Amplifier • Total output power: 100W RMS (30% THD)/ 75W RMS (10% THD) • Frequency response: 20 Hz-20 kHz / ±3dB • Signal-to-noise ratio: > 65 dB (CCIR) / (A-weighted) •... - Page 13 © 2011 Koninklijke Philips Electronics N.V. All rights reserved. sgptt_1123/05_v1...
Need help?
Do you have a question about the HTS3111/05 and is the answer not in the manual?
Questions and answers