Kubota G18 Operator's Manual page 174

156
ENGLISH
{ Replacing Fuses
Replacement of the fuse
1. Open hood.
2. Remove the blown fuse.
3. Place a new 10A or 15A or 30A fuse in position.
(1) Fuse location
(2) Slow blow fuse
IMPORTANT:
¡ If the new fuse happens to blow out within a short
time, contact your dealer for inspection and repair.
Never "jump" the fuse with wire or foil, etc.
a : Stamp or stick label "EPS MT"
b : Stamp or stick label "E/G STOP"
c : Stamp or stick label "IG/M"
v Protected circuit
FUSE NO. CAPACITY
(ID LABEL) (A)
EPS MT 30
E/G STOP 15
q
IG/M 10
Slow blow fuse
w
––
40
{ Replacing bulbs
(A) Replacement of the headlight bulb
1. Open hood.
2. Turn bulb socket to remove socket from headlight
housing.
3. Push bulb down and turn one quarter turn to
remove bulb from the socket.
4. Install new bulb to the socket.
5. Install the socket in housing.
6. Close hood.
Headlight bulb 12.8 Rated Voltage/1.04 AMP/15 MSCP
(B) Replacement of the Indicator light bulb
1. Open hood.
2. Turn bad bulb socket to the left.
And remove it.
3. Pull bulb from the socket.
4. Push new bulb into the socket.
5. Install the socket.
6. Close hood.
Indicator light bulb 14.0 Rated Voltage/0.27 AMP/2 MSCP
Protected circuit
Electric power steering
Moter circuit
Engine stop timer relay
Fuel pump, Head light
Power steering control
unit,etc
Check circuit against
wrong battery connection