Installing The Driver For Windows - Tascam US-144MKII Owner's Manual

Installing the driver for Windows

NOTE
• During driver installation, a warning that
"this software ... has not passed Windows
Logo testing" will appear. If this message
appears, click Continue to proceed with
the installation.
• During installation, you must connect,
disconnect and reconnect the unit in
steps 7, 8 and 9. You should complete
each of these installation steps in less
than one minute. Installation may fail if
you take too much time.
1 Confirm that the unit and the PC are
not connected by the USB cable.
2 Insert the included driver installation
CD-ROM into the PC where you will
install it.
3 Click the " Install Driver" button when
the screen below appears. (If this sreen
does not appear automatically, find
and open the "Autorun2.exe" program
in the "Autorun" folder on the driver
CD-ROM.)
4 When the language selection screen
(below) appears, select the language
you prefer and then click the "OK"
button.
3 – Installation
5 Click the " Install the Driver" button
when the screen below appears.
6 Read the contents of the License
Agreement, and select "I accept the
agreement" if you agree to the terms.
Next, click the "Install" button to start
installation.
7 When the screen below appears, use
the supplied USB cable to connect the
unit to the PC.
TASCAM US-144MKII
13