Firmware Upgrade Instructions; Tools And Software; Installation - Dell W2607C Service Manual

5. Firmware Update Instruction

5.1 Tools And Software

a. USB cable
b. USB drive
c. Application code xxxx.upg- The TV firmware code, with .upg extension.
d. NVM bin file (when needed)-New NVM binary code, with .upg extension.
e. Nvmtool_encr_64Mbusb11_dev.upg (when needed)-used to upgrade NVM bin file, only needed when release
come with new NVM bin file.
f. Upgrade application (when needed)- the upgrade firmware, with .upg extension.

5.2 Installation

5.2.1 Install firmware codes on your USB flash HD.
a. Create the following folder in root directory of USB drive: upgrades.
b. TV and upgrade firmware code (xxxx.upg) should be save under upgrades folder
c. In case need to update NVM bin file, place nvmtool_encr_64MBusb11_dev.upg under upgrades folder, and
rename NVM bin file to NvmCopyfromUsb.bin and place in root / directory
5.2.2 Install Hardware
a. Inserted the USB cable to Mini USB connector of the TV.
b. Connect USB flash HD to USB cable.
5.2.3 Install NVM bin procedure (When Needed)
1. Insert AC power cord while press the "CH ▼＂key of remote control (Illustration 1). Hold the key till upgrade
application shows up (Illustration 2).
2. Press VOL+ , VOL- , CH▼ , CH▲ remote control keys to select nvmtool_encr_64MBusb11_dev.upg then
28
Dell W2607C