Fitting The Cover; Set-Up; Switching On - Myenergi eddi 16A1P01H Installation Manual

8.7

Fitting the Cover

Step 1:
Re-place and screw in the two mounting bracket securing screws (2).
Step 2:
Re-place and screw in the two front cover screws (1)

9 Set-up

9.1

Switching On

After completing and checking the wiring of the supply, the heater(s) and the sensor(s):
Step 1:
Switch on the eddi via the circuit breaker or fused spur.
Step 2:
If it's not already on – switch the ON/OFF and Bypass Switch (underneath the eddi) to the ON
position.
Step 3:
After the eddi starts-up for the first time, there will be a start-up wizard.
There are two likely scenarios here. Either this is your first myenergi device or you are adding this device to
an existing myenergi home eco-system.
When you boot up your device you will see the below screen asking if this is "1
you are integrating into an existing system ("Additional device").
If you select "1
If you are integrating into a system that already has a 'Hub' or a myenergi device that
is already set to 'master' select "Additional Device" and this will then set the Master
and vHub on your new device to OFF.
NOTE: If you have 1 existing standalone myenergi device E.g. a zappi only, you may
need to select "1
connected to the internet.
Page 16 of 36
Device Installed" this sets the Master and vHub to ON at start up.
st
device installed" – you will need to do this if your first device is not
st
device installed" or whether
st