Haswill STC-8080H Quick Start Manual

STC-8080H Thermostat

Quick Start Guide

(Version 21.08.02GEN)

STC-8080H defrosting thermostat with one sensor and

two output relays to connect and control the

refrigeration and the defrosting unit. There is an editable

delay time for the over-temp alarm function.

1. Wiring Diagram

https://www.thermo-hygro.com

This unit does not output AC electricity; hence you have

to wire all live and null wires to each port; you may use

the jumper wire conveniently.

1 / 4

Table of Contents

Do you have a question about the STC-8080H and is the answer not in the manual?

Page 1 STC-8080H Thermostat Quick Start Guide (Version 21.08.02GEN) STC-8080H defrosting thermostat with one sensor and two output relays to connect and control the refrigeration and the defrosting unit. There is an editable delay time for the over-temp alarm function. 1. Wiring Diagram https://www.thermo-hygro.com...
Page 2 2. Function Menu Code Function Temperature for Refrigeration Starts Temperature for Refrigeration Stops Temperature Calibration Compressor Delay Time Over-temperature to Trigger Alarm (more than Alarm Delay Time Defrosting Cycle / Interval Time Defrosting Lasting Time https://www.thermo-hygro.com 3. Configuration The aimed temperature range was defined from “F1” to f2”;...
Page 3 key to change the value; Release all keys once it reaches your aim value; Step4 Repeat operation from Step 2 / 3 / 4 to adjust other parameters; After configuring all values, press the key to Step5 save data and back to normal monitor status. Attention: the modified value will be saved automatically and back to normal status if without operation in 30 seconds.
Page 4 This is not a step-by-step user manual; It just shows the key points. The new user should read the Full-Content Version User Manual https://www.thermo-hygro.com Haswill Electronics STC-8080H Copyright Haswill-Haswell All Rights Reserved 4 / 4...