Ethernet Connection - Robe Robin T11 Profile User Manual

4.8 Ethernet connection

The fixtures on a data link are connected to the Ethernet with ArtNet communication protocol.The control soft-
ware running on your PC (or light console) has to support Art-Net protocol.
Art-Net communication protocol is a 10 Base T Ethernet protocol based on the TCP/IP.Its purpose is to allow
transfer of large amounts of DMX 512 data over a wide area using standard network technology.
IP address is the Internet protocol address.The IP uniquely identifies any node (fixture) on a network.
The Universe is a single DMX 512 frame of 512 channels.
The Robin T11 Profile is equipped with 8-pin RJ- 45 socket for Ethernet input.Use a network cable category 5
(with four "twisted" wire pairs) and standard RJ-45 plugs in order to connect the fixture to the network.
RJ-45 socket (front view):
Patch cables that connect fixtures to the hubs or LAN sockets are wired 1:1,that is,pins with the same numbers
are connected together:
1-1 2-2
If only the fixture and the computer are to be interconnected,no hubs or other active components are needed.A
cross-cable has to be used:
1-3 2-6
If the fixture is connected with active Ethernet socket (e.g. switch) the network icon
bottom right corner of the screen:
Ethernet operation
Connect the Ethernet inputs of all fixtures with the Ethernet network.
Option " Artnet" (gMaI or gMA2 or sACN) has to be selected from "Ethernet Mode" menu at each fixture.
Set IP address (002.xxx.xxx.xxx / 010.xxx.xxx.xxx) and the Universe at each fixture.
(DMX address=225)
IP addres=002.168.002.004
Universe=1
An advised PC setting: IP address: 002.xxx.xxx.xxx (Different from fixture IP addresses)
1- TD+
2- TD-
3- RX+
4- Not connected
3-3 4-4 5-5
3-1 4-8 5-7
(DMX address=25)
IP addres=002.168.002.003
Universe=1
NET mask: 255.0.0.0
5- Not connected
6- RX-
7- Not connected
8- Not connected
6-6 7-7 8-8
6-2 7-5 8-4
15
RJ-45 plug (front view):
will appear at the
(DMX address=1)
IP addres=002.168.002.002
Universe=1