Related Manuals for Corsiva Yachting CORSIVA 500 TENDER
Summary of Contents for Corsiva Yachting CORSIVA 500 TENDER
- Page 1 OWNER'S MANUAL MOTOR BOAT CORSIVA 500 TENDER Manufacturer Corsiva Yachting http://corsiva.pl/...
-
Page 2: Table Of Contents
CORSIVA YACHTING INDEX 1. INTRODUCTION ............................. 2 2. STAGE OF DANGER ............................3 3. GENERAL SAFTY RULES ........................... 4 3.1. Safety ................................4 3.2. Passengers on board ........................... 4 3.3. Life-saving equipment ..........................5 4. IDENTIFICATION OF BOAT ..........................6 4.1. -
Page 3: Introduction
The Owner’s manual, which you received together with a boat, will help you to operate your motor boat CORSIVA 500 TENDER safely and appropriately so you may use it with a pleasure. Manual contains the description of the boat, its equipment and installation systems as well as practical information about their use and maintenance. -
Page 4: Stage Of Danger
CORSIVA YACHTING 2. STAGE OF DANGER The manual contains three kinds of sign, which are supposed to turn your attention to the actions and situations which may cause danger for health or life if not realized. Following: DANGER The sign warns before appearing the highest danger, which can cause the durable damage of body or death unless the appropriate safety actions are taken. -
Page 5: General Safty Rules
CORSIVA YACHTING 3. GENERAL SAFTY RULES 3.1. Safety Even if it all planned the safety of the sailing remains heavily dependent on the weather, sea conditions and the experience and knowledge of the crew. Always check to-date weather forecast before leaving and see that the circumstances should be expected to the category of construction of the boat. -
Page 6: Life-Saving Equipment
CORSIVA YACHTING 3.3. Life-saving equipment On the yacht should be appropriate safety equipment (life jackets, safety harnesses, etc.) as appropriate to the type of boat, weather conditions, etc. In some countries it is Required equipment. Carefully read the manual of a life raft. -
Page 7: Identification Of Boat
Annex I to Directive 2013/53/UE of European Parliament and of the Council, Recreational craft and personal watercraft. The boat CORSIVA 500 TENDER was put to the test by Polish Register of Shipping according with applicable requirements of Annex I to Recreational Craft Directive 2013/53/UE for design category C. -
Page 8: Builder's Plate
CORSIVA YACHTING 4.2. Builder's plate In the cockpit of CORSIVA 500 TENDER there is placed the builder’s plate. The builder’s plate includes: Yacht design category – „INSHORE”. Max. number of people and personal equipment which cannot max. x 5 +... -
Page 9: Stability And Buoyancy
CORSIVA YACHTING 5. STABILITY AND BUOYANCY... - Page 10 CORSIVA YACHTING DANGER Information about stability and freeboard, floatation and buoyancy is fulfilled only when: The weight of empty boat with equipment does not exceed 695 kg, The maximum power of engine does not exceed 44,7 kW Remember: ...
-
Page 11: Weight Of Boat And Maximum Capacity
CAUTION Never cross the safety limit definite by constructor in reference to the maximum load of boat. CORSIVA 500 TENDER can accommodate maximum 5 people + fuel, equipment, gear, outboard engine maximum 700 kg. The maximum recommended load takes into account the weight of all persons on the boat, all stocks and personal items, all the equipment is not included in the weight of the empty boat, cargo (if any) and all of consumable liquids (water, fuel, etc.). -
Page 12: Description Of Boat
CORSIVA YACHTING 6. DESCRIPTION OF BOAT The yacht is made of durable glass-reinforced laminate as a monolithic construction and of high class materials, guaranteeing trouble-free use of boat for years. CORSIVA products are applied with such technical solutions which allow to get the optimal stability, reliability and control at the swerves as well as safety at overcoming waves. -
Page 13: Engine
CORSIVA YACHTING 7. ENGINE If a customer wishes, the boat is sold with outboard engine placed in the well in cockpit. In other cases, the manufacturer leaves routed wiring in the engine sump to the customer in the future he could connect the motor (photo). -
Page 14: Engine Compartment
CORSIVA YACHTING 7.1. Engine compartment Hiding the engine in compartment makes it easy boarding or leaving from the deck while the boat is moored stern. Additionally, hidden engine reduces the noise, which produces a running engine, improving for crew comfort during cruises. -
Page 15: Mechanical Ventilation
CORSIVA YACHTING 7.1.1. Mechanical ventilation The exhaust gases from the engine exhaust are discharged through a hose, which on one hand is connected to the engine, and on the other to the end of exhaust, which are exhausted out of the boat. -
Page 16: Steering System
CORSIVA YACHTING 8. STEERING SYSTEM 8.1. System of steering the boat System of steering the boat’s rudder by the steering-wheel. Steering with an engine is regulated with the engine throttle, which is placed on the right side in cockpit. The throttle changes the speed and the direction of driving screw. - Page 17 CORSIVA YACHTING Navigational aids. Current receiver. Engine switch on and off Emergency switch off of engine The emergency switch which stop the engine in moment of danger, for example: in moment when overboard the helmsman. You can’t it use in normal stop of the engine.
-
Page 18: System Of Steering
CORSIVA YACHTING 8.2. System of steering CORSIVA 500 TENDER boat is equipped with a mechanical control boat. It consists of: steering wheel, gear, steering system, steering links. CAUTION The control system requires periodic inspection, especially pay attention to: ... -
Page 19: Fuel System
CORSIVA YACHTING 9. FUEL SYSTEM The boat is equipped with a portable fuel tank made of plastic with capacity of 30L, which is placed in the aft locker. The fuel tank has a fuel gauge in his cap. Every fuel of tank is made according to PN EN ISO 10088 and have sign CE. -
Page 20: Electric Installation
CORSIVA YACHTING 10. ELECTRIC INSTALLATION The boat is equipped with electric installation of direct current = 12V. The main source of the boat is the battery with a capacity of 30 Ah to 72 Ah. The battery is located in compartments. - Page 21 CORSIVA YACHTING CAUTION Remember, before starting work, turn off the main power switch! Main power switch. Scheme of electric installation* *) Scheme of electric installation depends on the equipment ordered by customer.
- Page 22 CORSIVA YACHTING...
-
Page 23: Sanitary System
CORSIVA YACHTING 11. SANITARY SYSTEM On the boat is provided a chemical toilet in bow compartment. The rules of its use and maintenance are described in the manual book of WC manufacturer CAUTION Before using the toilet make sure it is open water intake valve. -
Page 24: Bilge Instalation
CORSIVA YACHTING 12. BILGE INSTALATION The bilge system is installed in the galley under the floor. Bilge pump suction nozzle Hand bilge pump under the deck Consists of: 1. Electric bilge pump, 2. Manual bilge pump, 3. Drainage hoses to the bilge water 4. -
Page 25: Bottom, Side Sea Openings
CORSIVA YACHTING 13. BOTTOM, SIDE SEA OPENINGS The openings in deck, bottom and side may pose a danger as water can get into the boat. Sea valves are served manually, therefore they should be controlled. The outflow from anchor locker to broadside... -
Page 26: Fire Protection
CORSIVA YACHTING 14. FIRE PROTECTION The main source of fire on the boat is open fire such as a lighter or candle. WARNING Before using you should: get to know with manufacturer’s instruction in detail equip the boat with fire extinguisher and extinguishing blanket, ... -
Page 27: Sundeck
CORSIVA YACHTING 15. SUNDECK According with customer's wish the boat of superstructure can stand the place to sunbathing for crew. You should turn the special attention on behaviors of principles of safety and proper care of mattresses. DANGER Forbidding of transport the children's less 5 years old on stern sundeck and juvenile without lifejackets and parents or the guardians control. -
Page 28: Upholstery
CORSIVA YACHTING 15.1. Upholstery The upholstery should be installed according to the scheme as pictured. Each pillow mattresses has its own designation will help replacement of individual cushions, when it will be destroyed. Upholstery marked with the letter E -... -
Page 29: Maintenance, Painting, Cleaning
CORSIVA YACHTING 16. MAINTENANCE, PAINTING, CLEANING Your boat – the deck, hull and some interior parts were made of fiberglass. To keep the boat in good condition, wash the fiberglass regularly. Wash the boat with clean water with soft detergents, e.g. water with soap. -
Page 30: Stainless Steel
CORSIVA YACHTING 16.1. Stainless steel Constructions of bow and stern railings, as well as other metal elements were made of corrosion resistant steel, which means polished stainless steel. WARNIG If you want to keep stainless steel fitting in good state, you should: ... -
Page 31: Trailering
CORSIVA YACHTING 17. TRAILERING During the boat transportation it is very important to keep the boat in the horizontal position. Lifting belts should be in the places appointed with the red triangle on a hull according to the following drawing. -
Page 32: Anchoring, Mooring And Towing
CORSIVA YACHTING 18. ANCHORING, MOORING AND TOWING The owner of a boat / helmsman is responsible for equipping the boat with an anchor, anchor chain / anchor rope, mooring and towing lines ready to use. Anchorahe eguipment Place the anchor in the anchor compartment. Anchor rope is secured to the cleats. -
Page 33: Environmental Protection
CORSIVA YACHTING 19. ENVIRONMENTAL PROTECTION The chapter contains the indispensable information how you should protect the natural environment during sailing, as well from the crew as from the boat side. There are strict requirements concerning the respect of natural environment not only in many parts of Europe but also all over the world. -
Page 34: Removing Failures
CORSIVA YACHTING WARNING If the bilge water are dirty avoid the the work of automatic bilge pump, do not remove the illegal plants. Do not remove the contaminated bilge water overboard. Sewage removal should take place in appointed places on land. -
Page 35: Warranty
The statement should be in duplicate: for the customer and the boat seller. 1. Manufacturer CORSIVA YACHTING Artur Grugel with headquarters in Ciechocin it gives guarantee on motor boat CORSIVA 500 TENDER number CIN: - C O R −... - Page 36 9. Guarantee period becomes prolonged about time of possible guarantee repairs. 10. CORSIVA YACHTING Arthur Grugel it does not bear no responsibility for possible financial losses or different legal after-effect, caused pronouncement defect in complaint boat.
- Page 37 CORSIVA YACHTING 16. In matters not regulated by the provisions of the relevant provisions of the Civil Code.
- Page 38 CORSIVA YACHTING Records warranty. Date Note about repair Date Guarantee Date, raising the realization signature and claim the repair prolonged stamp...
Need help?
Do you have a question about the CORSIVA 500 TENDER and is the answer not in the manual?
Questions and answers