Fujitsu F2MC-8L MB89051 Series Operation Manual page 9

I Connecting the probe header to a user system
To connect the probe header and the user system, connect the probe header to NQPACK064SB*
mounted on the user system using YQPACK064SB.
1) An index mark (one corner of the YQPACK064SB or NQPACK064SB is clipped) indicates the
first pin on the YQPACK064SB and on the NQPACK064SB. Mount the probe header by using the
index marks to align the first pins.
2) After connecting the probe header to the user system, secure the probe header using the supplied
screws*. Secure the probe header to the NQPACK064SB by inserting the screws in the holes
drilled in the four corners of the mounting part of the MCU. Be sure to secure the probe header
evenly at the four corners with the screws. Tightening the screws too much may damage the probe
header and NQPACK064SB.
*: The NQPACK064SB and screws for securing probe header are supplied with the product.
Probe header
YQPACK064SB
NQPACK064SB
Figure 4 Connecting the probe header to a user system
Screws for securing
probe header
User system
5