Setting Cutting Angle; Instructions For Use - HOLZMANN MASCHINEN TS 250 User Manual

14.2.4 Setting cutting angle

 Loosen the clamping lever A for the locking
 To the saw blade by the tilt 90° - 45 ° is used to adjust the wheel B on the side of the ma-
chine
 Pull after setting the clamping lever A solid again.
Fig. 16
14.3

Instructions for use:

7.3.2 Notes on using the circular saw
 Make sure you install the saw blade protection.
 Run the workpiece evenly without flare-ups and without take it back until the end of cutting to.
 Set the circular saw blade so high that the ring gear is really reliably covered by the circular
saw blade protection (distance between the circular saw blade guard and workpiece (max. -. 5
mm )
WARNING: Perform the setup of the circular saw blade height and tilt by only with the machine
switched off.
For cuts less than 120 mm width supplying
the material with a push stick must be made,
and the stop bar must be in a flat position.
Fig. 18
HOLZMANN Maschinen Austria
Handwheel
height
www.holzmann-maschinen.at
OPERATION
Fig. 17
Fig. 18
Seite 32
Tischkreissäge / table saw TS 250