Scantech IREAL 2E Quick Manual

TM
Quick Guide
Equipment list
① ②
Scanner Calibration board
④ ⑤
Adaptor Cable
⑦ ⑧
Software Dongle
⑩
E-AR Display (optional)）
Scanner structure
Intelligent fill system
black and white camera
light source module
Start/Pause Scan Button
black and white camera
Color camera
Computer Specifications (Recommended)
OS： win7/10, professional, 64-bit (recommended)
CPU： i7-8750H or higher
RAM： 32G or above (64G is best)
Graphics card： NVIDIA GTX1050Ti (4G) or above
Ports： USB3.0 port
Software and hardware
01
③
Plug cable and connect it to the USB3.0 of the computer, then turn on the
power.
Note: It must be USB3.0 port; first plug the USB and then the power.
①
Mark point
⑥
④
Waterproof box
⑨
02
Take the USB stick in the device case, plug it into the computer, Copy
the software package than double click the software to install it.
USB stick
03
Set up the computer and software according to the "Training Course".
04
Take the dongle of the device box, plug it into the computer USB port,
double clicktrun the scansoftware and star t calibration/scanning
Terms & Conditions
*Before using the device , please read the quick guide, training tutorials, and the comments
for each button on the software.
Smart Indicator
*Suitable for scanning objects over 50cm, especially for portraits, body
Green: Suitable distance/software/
parts and medium-sized sculptures.
hardware connected
*The plate is fragile, please handle it with care.
Red: Too far away/device not connected
Blue: Too close
* In bright light sources (e.g., Sunlight), Shading is required to scan.
Yellow: not stitchable.
*The dark, black, transparent, or reflective objects will need spray contrast enhancer
before scanning.
power socket
data port
*when do scanning Plug laptop power source and set the power supply to High
Performance mode.
* When runs the software, if the software says "device not connected"/"wrong USB
recognition" or the scanning is stuck, please turn off the software, replug the USB
port (or change to other USB3.0 port/use USB3.0 Hub adapter). ).
*When using a desktop computer, please use the USB 3.0 port on motherboard
*Press the Start/Pause Scan button on the scanner once, no need long press
*When first time runs the software, it needs calibrated before scanning; please do
re-calibrate when the number of single-frame outputs/stitching/marker recognition
rate is low.
*Do not use it with other scanners (before using it, you need to turn off the other scanner's
software and unplug the other scanner from the computer).
installation
Note: The power cord is marked with
an arrow, so please flip the arrow to
the top and align the four thimble
pins with the power port jack before
gently plugging them in.
⑤