These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: WALL4LSS / WALL5LSS SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
Page 3
Suitable IP rated junction boxes should be used where required Suitable IP rated junction boxes should be used where required Carefully remove the two nuts and O-rings securing the baseplate to the luminaire (see Fig. 1) • Carefully remove the two nuts and O-rings securing the baseplate to the luminaire (see Fig. 1) Fig.
Page 4
the luminaire to the mains supply ensuring that correct polarity is observed (see Fig. 3 wn), E - Earth (green/yellow), N - Neutral (blue) • Connect the luminaire to the mains supply ensuring that correct polarity is observed (see Fig. 3): L - Live (brown), E - Earth (green/yellow), N - Neutral (blue) Fig.
Page 5
Switch on power to the fitting and conduct a walk test – this is to check the area that the sensor is detecting, and to adjust the detection setting as required Fig. 4 • Once the detection area is set, adjust the time and lux settings as required. Turn the power to the luminaire Once the detection area is set, adjust the time and lux settings as required.
If this product should fail within its warranty period it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve...