Control Wiring - Sony VPL-CX10 Quick Start Reference Sheet

Hide thumbs Also See for VPL-CX10:

SmartPanel Projector Driver Application Note

II. CONTROL WIRING

PROJECTOR CONTROL

RS232

Wired Remote to

Control S

This section specifies how Wired Remote or IR should be

wired to the projector.

The Wired Remote should be connected to the Sony port

IR/SERIAL

labeled Control S. Connection should be as follows:

1. Wire the Panel to a female 1/8" Mini as shown; wire

IR/SER to tip and GND to ring. Direct wiring to male

1/8" is not recommended as it makes removal of the

Panel for service more difficult.

Attach to the projector port labeled Wired Remote using

a male 1/8" mini to male 1/8" mini (not included).

3. Alternately, replace the male to male cable with the

included the IR Emitter and attach it to one of the IR

windows on the projector. The emitter glows red when

1/8" Mini

Female

IR is emitted so wiring can be verified.

Sony VPL-CX10

help@spcontrols.com

Table of Contents