Advertisement
5.11.
ATTACHING THE BACK STRAP
5.11.1.
Feed the back strap through the fixed link pin (fig 10).
5.11.2.
Feed the back strap through the upper slot of the plastic buckle (fig 11), and then through the lower slot of the plastic buckle and
pull tight (fig 12).
5.12.
ATTACHING THE BOTTOM CLIP
5.12.1.
Hook each bottom clip onto it's corresponding tab at the base of the sprayer (fig 13).
5.13.
BACK STRAP ADJUSTMENT
Adjust the back strap so that the sprayer is in a comfortable position and as close as possible to the body.
9
5.13.1.
To lengthen the strap, lift up the buckle (fig 14), and pull the belt through from the side connected to the sprayer.
5.13.2.
To shorten the strap, lift up the buckle (fig 14), and pull the belt through on the free side.
WARNING! Ensure that the back strap is securely attached to the sprayer.
‰
5.14.
ATTACHING THE SPRAY PIPE HOLDER
5.14.1.
Fully slide the pipe holder over the pipe holder boss (fig 15).
5.14.2.
Insert the spray pipe into the pipe holder (fig 15).
5.14.3.
To remove the pipe holder lift it up and off the pipe holder boss and place in a secure location.
6. OPERATION
NOTE: Ensure all Safety Instructions in Section 1 are read and understood and carried out before use and save the instructions and
warnings for future reference.
6.1.
POWER SWITCH
WARNING! Ensure that the sprayer power switch is in the OFF position prior to installing the battery cartridge.
‰
WARNING! To prevent sudden spraying ensure that the trigger lever is in the stop position and the power switch is in the OFF
‰
position.
6.1.1.
To turn the sprayer on, press down the I (ON) on the power switch (fig 16).
6.1.2.
To turn the sprayer off, press down the O (OFF) on the power switch (fig 16).
Fig.16
6.2.
OPERATING THE SPRAYER
6.2.1.
To operate the sprayer depress the trigger lever to spray, then release the trigger lever to stop (fig 17).
6.2.2.
For continuous spraying depress the trigger lever and while it's depressed push forward to lock on.
6.2.3.
To lock off pull the trigger lever back and release (fig 17).
6.3.
SPRAYING
6.3.1.
When using the sprayer firmly grip the control handle.
6.3.2.
Once spraying is complete release the trigger lever to stop and turn the power switch to OFF.
6.4.
SPRAY ADJUSTMENT
6.4.1.
To adjust the intensity of the spraying turn the adjustment button clockwise to increase and anticlockwise to decrease (fig 18).
DO NOT operate the sprayer with an empty tank. Turn OFF immediately.
8
DO NOT use the sprayer with the battery cover open or with the back pad removed.
8
WARNING! Prolonged continuous use of the sprayer will drain the battery and may cause damage to the pump. Switch OFF the
‰
sprayer whenever possible.
WARNING! If the sprayer starts to make abnormal noises and/or the spray splutters this indicates that the tank is empty.
‰
Switch OFF immediately.
6.5.
FILLING THE TANK
WARNING! Ensure that the sprayer power switch is in the OFF position prior to filling the tank.
‰
6.5.1.
When filling the tank ensure the tank filter is fitted into the top of the tank (fig 23).
6.5.2.
Fill the tank with the required volume utilising the level indicators on the tank.
6.5.3.
Firmly tighten the tank lid after filling.
NOTE: Maximum volume of tank = 15L.
WARNING! When filling the tank wear appropriate PPE.
‰
WARNING! DO NOT fill tank in a poorly ventilated area.
‰
7. MIXING CHEMICALS
WARNING! Ensure that all chemical mixtures are thoroughly dissolved prior to use.
‰
WARNING! Take extreme care when handling chemicals. Wear appropriate PPE. Wash thoroughly away any chemicals that comes
‰
into contact with bare skin.
WARNING! Chemicals are harmful. Always read and fully understand the manufacturers instructions before use.
‰
© Jack Sealey Limited
Fig.13
Original Language Version
Fig.14
Fig.17
CP20VGBS Issue 2 (2,3) 18/02/22
Fig.15
Fig.18
Advertisement
