Advertisement
IMPORTANT NOTE FOR OEM INTEGRATOR
This is single module which has been tested and complied with Part 5.247/15.407,and RSS-247 requirements.
Host device needs to be labeled with module's FCC/IC IDs, for example, "Contains Transmitter module FCC ID:
A3LCWBR720M , IC:649E-CWBR720M ".
This device is intended only for OEM integrators under the following conditions:
1) This module may not be co-located with any other transmitters or antennas.
2) The antenna must be installed such that 20cm is maintained between the antenna and users.
3) Only the antenna type and antenna gain documented in the module FCC/IC reports can be used.
4) For Canada, this device is limited to indoor use when operating in 5150-5250 MHz to reduce the potential for
harmful interference to co-channel mobile satellite systems.
As long as above conditions are met, further test or certification will not be required. However, the OEM integrator is
still responsible for host product evaluation or any additional compliance requirements with this module installed. In
the event that these conditions cannot be met, then the FCC & IC authorizations are no longer considered valid and
the FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product including this module and obtaining separate FCC & IC authorizations.
5) Additional testing, Part 15B disclaimer
This module only complied with FCC 15.247/15.407 requirements as listed on the grant, and therefore, the host
product manufacturer is responsible for FCC Part 15B compliance testing with the module installed.
Version 1.0
Samsung Electronics
page 6 of 6
Advertisement
