Canon Science Papercraft Biology Series Quick Start Manual

Science Papercraft Biology Series
Canon Science Papercraft Mini-book
Eudimorphodon
Biology Series
The pterosaurs were flying reptiles that lived at
the same time as the dinosaurs.
Eudimorphodon was one of the earliest
pterosaurs, and had a long tail and short neck.
Its tail served as a rudder to steer with while
gliding. It is thought that the Eudimorphodon
would leap from tall cliffs and fly utilizing
updrafts, like a modern glider.
*Cut out the card above and save it. You can collect the cards from each of the Papercraft
projects to make your own mini-book!
Directions
* Items needed: one paper clip
Print out pages 1 and 2, cut out each individual part along their cut lines,
and fold along the mountain and
valley fold lines.
1.
Build the body
Glue the body, head,
legs (top)
and legs together as shown
in the figure.
2.
Build the wings
Glue the wings to the body.
side view of the wings
Back Front
Bend the wings as shown
in the figure above.
Eudimorphodon
The
head (left)
body (left)
body (right)
head (right)
legs (bottom)
3.
Adjust
Adjust the wings so that the right and left
side match when viewed from the front,
as shown in the figure below.
wings
legs
Clip a paper clip onto the head.
attach a paper clip
After the glue is fully try, you're ready for a
test flight! Adjust the left and right legs up
and down and adjust the position of the
paper clip until you get the Eudimorphodon
to fly well.
* Don't fly the Eudimorphodon directly at
another person.
(section 1)
Left wing (top)
Right wing
Right wing
(bottom)
glue wing top here
Left wing (bottom)
(top)
glue wing top here