General Warnings - Italforni EGA/LE Use And Maintenance Manual

The oven is fitted with atmospheric burners located under the refractory racks of the cooking
chamber. The temperature of the chamber is set using an analogue thermostat located on the
control panel. Once the set temperature is reached, the burner will alternate on and off cycles to
maintain this temperature.
If the burner should fail to ignite, a red warning light turns on and then ignition can be attempted
again by pressing the reset button. In the event of excessive or irregular heating of the cooking
chamber, a safety thermostat is triggered which blocks the flow of gas and turns the oven off; this
can only be reset manually.
1.1 – General warnings
 Read this manually carefully as it provides safety instructions for use and maintenance. The
purpose of this manual is to make operators aware of the rules and essential criteria to ensure
their safety and extend the oven's service life. This manual must be read by all staff authorised
to work on the appliance before its commissioning.
 This instruction manual must be keep with the oven for future reference. If the oven is sold or
transferred, make sure that the manual always accompanies it, so that the new user can be
informed about its operation and the safety warnings. It must be kept in a safe and dry place
that can be quickly located whenever it needs to be referred to. If it damaged or lost, contact
the manufacturer directly for a replacement copy. For any doubts, contact your nearest service
centre or the manufacturer directly.
 Put the appliance into service in accordance with the regulations in force. These instructions
only apply to category II2H3+ pizza oven models.
 This oven is intended for the following use: cooking pizzas or similar foods. It must not be used
for other purposes; any other use is considered improper. The appliance is intended for
collective and professional use and must be operated by trained staff.
 Servicing, conversion to other types of gas, installation and operational checks must only be
performed by qualified staff.
 Each time a new part is fitted or a component is adjusted, make sure that it is sealed with paint
to discourage any tampering.
 It is advisable to take out a maintenance contract.
Use and maintenance manual
5