Table of Contents
Advertisement
INSTALLATION
Installation
1. Remove the packaging materials and tapes
Remove all transportation packaging materials and
tapes. Open the doors and ventilate the unit. If
the outside panels are dirty, clean them with a
diluted neutral dishwashing detergent. (Undiluted
detergent can damage the plastic components.
For the dilution, refer to the instruction of the
detergent.)
After the cleaning with the diluted
detergent, always wipe it off with a wet cloth.
Then wipe off the panels with a dry cloth.
2. Adjust the leveling foot
Extend the leveling feet by rotating them as shown
in the figure until they make contact with the floor.
Ensure the unit is level. (Fig. 1)
3. Fix the unit
Two fixtures are attached to the rear of the frame.
Fix the frame to the wall by attaching a rope or
chain between the wall and the fixtures.
4. Install the filter
Install the condenser filter at the front bottom of the
cabinet. (Fig. 2)
4. Ground (earth)
WARNING
Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet is
not grounded, it is necessary to install a ground by qualified engineers.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
grounding may cause electric shock in the case of an incomplete circuit.
Leveling foot
12
Fig. 1
Fig. 2
Hide quick links:
Advertisement
Table of Contents
